Seneca S6001-RTU, User Manual

Page: 32 / 210

USER MANUAL – Z-TWS4/Z-PASS2-S/S6001-RTU
32
The SDD can be easily installed by running the installer program available at the following link:
http://www.seneca.it/products/sdd
NOTE:
- when the Device is working in “Switch” mode, the IP Address shown by the SDD is the same regardless of
the Ethernet port which the PC running the SDD is connected to;
- when the Device is working in “LAN/WAN” mode, the IP Address shown by the SDD is the LAN IP Address
when the PC is connected to the LAN port, the WAN IP Address when the PC is connected to the WAN port;
moreover, the network configuration parameter changes apply to the relevant port.
7 FTP/SFTP access
To easily access the Device by means of FTP/SFTP, you can use the WINSCP™ program; you can free
download WINSCP™ from:
http://winscp.net/eng/download.php
You must set the connection as in the following figure (the screenshot shows a connection to the
192.168.85.106 IP address):
The credentials (username and password) are those (“user”, “123456”) set for the “FTP USER” (see “Users
Configuration” web page in paragraph 18.1.7).