BALANCE BIKE SEESAW MODE
BUILDING AND ATTACHING THE HEIGHT ADJUSTMENT LEG
Take the LARGE Hinged Plate and the Height Adjustment Plate with Feet. Place this as shown below. We will start with these
components in 200 mm high mode. Place an M10 x 40 Button Head Bolt through the front plate and into the hinged plate at
either end. Tighten with the 6 mm Allen key or Torque to 12Nm
There is a Central Bolt which is not engaged / needed at 200 OR 250 MODE. You can place this into the T Nut holes for Storage.
MAKING AN EASY ANGLE 200 mm HIGH JUMP RAMP
ATTACHING THE SURFACES TO THE HEIGHT ADJUSTER
Take the 1200 mm long surface you created by using the Joining Plate and turn this so that the SKILL / PLAY STATION TEXT is at
the same end as the Height Adjuster. The orientation of the surfaces is important because the surface will not touch the ground
if REVERSED!
Line the Holes in the surface with holes in the hinged plate on the Height Adjuster. Use 3 x M10 x 35 mm Countersink Bolts to
hold the surface to the adjuster. Locate the bolts into the t nuts by hand first. Then secure with the 6 mm Allen Key. Secure to
12Nm.