Sencore MRD 3187B, User Manual

Page: 128 / 203

MRD 3187B User Manual
Page 127
RDS 1
►Service Setup
Sdi Aud Embed
Video Status
RDS1 Serv Setup
►Tune Mode :Pid Lock
PID Select :Manual
PCR PID :0x0000
4.20 MPEG-2/MPEG-4 Decoder with Genlock (1 Video, 2 Audio) – Option
8731A/8734
General Information
Install Location: Not Field Upgradeable
I/O: The input and output is done through the various other I/O cards. (e.g. 8701)
Supported Formats: 8731A: MPEG2 and all formats supported by the option cards.
8734: MPEG2, MPEG4, and all formats supported by the option cards. Both cards
support
genlock between compatible option cards.
Description: The MRD 3187B can be configured as a Single RDS or as a Dual RDS. As a
Single RDS, the MRD 3187B has only one MPEG Decoder. As a Dual RDS the MRD
3187B has two MPEG Decoders. The MRD 3187B can be configured, when ordering, to
act as two separate RDSs or as one RDS with two decoders to enable four audio
processors.
Decoder Setup
To setup the MRD 3187B to be able to decode the incoming audio and video use the
following steps.
1. Press the button to bring the display back to the RDS status screen.
2. Press the button to access the RDS 1 Decoder Menu.
Note: For Configuration 2 units, all of the following
instructions apply exactly the same except, use the
button to access the RDS 2 Decoder Menu.
3. Use the and buttons to move the cursor
to, “Service Setup,” then press the
button.
4. Press the button again to display the Edit
screen for the RDS 1 Decoder.
Tune Mode
1. Use the and buttons to move the
cursor to, “Tune Mode:” then press the
button.
2. Use the and buttons to select the
desired mode (Auto, No PSI, PID Lock,
Priority), then press the button to save
the selection.
PID Lock Mode
This mode is the most desirable and will produce
the most consistent output. If possible this mode
should
always be used.