SMP100 User Guide
8
Before you configure input, go to
Equipment Configuration > System
, and set the
Output
TS Standard
. By default, it is DVB.
Embedded TSIP Input
By default, the input and output TSIP channels are closed.
Steps to configure an IP input:
1. Go to
Module Configuration > TSIP [Embedded] > Setup
. Set the network parameters of the
built-in TSIP module. Click
Apply
in this page before next step.
2. Go to
Module Configuration > TSIP [Embedded] > Channel (1-16)
. Check the boxes under
Channel Enable
to open IP input channels. Enter the
Source IP Address
,
Source Port
and
Protocol
(UDP/RTP). Click
Apply
in this page before next step.
