EN - 7
SIGNAL STRENGTH INDICATOR
The signal indicator displays signal strength in 4 levels. Wave segment flashing means
time signals are being received. The signal quality could be classified into four types:
NOTE:
- Everyday the unit will automatically search for the time signal at 2:00am, 8:00am,
2:00pm and 8:00pm
- The strength of radio-controlled time signal from the transmitter tower may be affected
by geographical location or building around.
- Always place the unit away from interfering sources such as TV set, computer, etc.
- Avoid placing the unit on or next to metal plates.
- Closed areas such as airport, basement, tower block, or factory are not recommended.
TIME SETTING
The unit automatically set itself accordingly to the Radio Controlled Clock signal it received.
To set the clock/ calendar manually, first disable the reception by holding the RCC key for
8 seconds.
TO MANUALLY SET THE CLOCK / TIME ZONE SELECTION
1. Press and hold
[TIME]
key for 2 seconds until 12 or 24 Hr flashes.
2. Use
[UP]
or
[DOWN]
key to adjust, and press
[TIME]
key to proceed to the next set-
ting.
3. Press
[TIME]
key again to step the setting items in this sequence: Hour format
Hour
Minute
Second
Year
Month
Day
Hour offset
Weekday Language
DST AUTO / OFF.
NOTE:
- The unit will automatically exit setting mode if no key was pressed in 60 seconds.
- The hour offset is for DCF and MSF version. Its range is between -23 and +23 hours.
-
DST
(Daylight Saving Time) feature is set to Auto (factory set).The clock has been pro-
grammed to automatically switch when the daylight saving time is in effect. User can set
the
DST
to
OFF
to disable the feature.
DISABLE / ENABLE RCC SIGNAL RECEPTION
1. Press and hold the
[RCC]
key 8 seconds to disable the reception.
2. Press and hold the
[RCC]
key 8 seconds to enable automatic RCC reception.
SETTING ALARM TIME
1. In normal time mode, press and hold
[ALARM]
key for 2 seconds until the alarm hour
digit flashes to enter alarm time setting mode.
2. Press
[UP]
or
[DOWN]
key to change the value. Press and hold the key for quick-ad-
just.
3. Press
[ALARM]
key again to step the setting value to Minute with the Minute digit flash
-
ing.
4. Press
[UP]
or
[DOWN]
key to adjust the value of the flashing digit.
No signal quality
Weak signal quality
Acceptable signal quality
Excellent signal quality
RRC on
RRC off
