Sencor SWS 211, User Manual

Page: 6 / 12

EN - 4
Insert the holder to the bottom of the outdoor transmitter for desktop or insert it to the back of the
transmitter for wall mount purpose.
Remarks:
During reception of the DCF time signal, your thermometer does not take temperature
measurement. It will change to low brightness and will resume to high brightness after auto
reception. After
fi rst time installation, the temperature readings will get stable and become more
accurate in around 30 minutes.
Battery Back Up
When AC power is off, the batteries will power the clock to keep track of the time and alarm time.
When only the back-up batteries are used, the LED panel is off.
Power Up Reception and Signal Strength Display
1. After your thermometer receives the outdoor temperature, it will starts to receive DCF signal.
icon blinks. Display shows .
2. When strong DCF signal is detected, display shows with 3 bars . When weak or no DCF
signal is detected, display shows with 1 bar or . You will need to replace the
clock to another area for better reception, or unplug the power jack to start over reception again.
During reception, the signal strength may move from 1 bar to 2 bars to 3 bars. This is normal
since the clock is detecting DCF signal and other signals in the air at the same time.
3. If the clock does not catch DCF time signal for 21 minutes. It will stop to search for the DCF
signal.
4. During reception, press TIME button once will go to normal time display. Press WAVE/HR again
will return to reception mode and signal strength indication.
Successful Reception or failed reception
icon becomes static (stop blinking) when reception is successful.
icon disappears when reception is failed.