Vacuum cleaner
SVC 730RD / SVC 730GR
EN
EN-9
05/2019
Copyright © 2019, Fast ČR, a.s.
Cleaning of filters
All filters inside the vacuum cleaner are washable. If they are soiled wash them under running lukewarm
water. If the filters are so soiled that washing does not help, replace with new filters. Before placing the
filter back into the vacuum cleaner ensure that it is completely dry.
Warning:
The vacuum cleaner is equipped with a heat safety fuse, which in the case of over-loading
(e.g. blocked filters) will turn it off. The vacuum cleaner may then only be switched on
once it has cooled.
For this reason carry out regular cleaning, i.e. replace filters – this will
extend the life of your vacuum cleaner.
Cleaning your vacuum cleaner.
Use only clean, soft and dry cloth. However, you may dip the cloth slightly into water. Do not use
aggressive solutions or paint thinners!
TROUBLESHOOTING
Before you decide to contact authorized service centre, read these following tips in the
troubleshooting chart:
Problem
Possible cause
Recommended action
The engine will not
start
- The supply cable is not connected
correctly in the wall power outlet.
- The wall power outlet is damaged.
- The vacuum cleaner is not switched on.
- Inspect the supply cable plug.
Make sure that it is firmly
inserted in the wall outlet.
- Inspect the wall outlet.
- Turn the appliance on.
The suction output is
insufficient
- Vacuum cleaner or its air passageways
are clogged with dirt of foreign object.
- The dust filter needs cleaning.
- The dust container
5
has been installed
incorrectly, or in wrong position.
- Filter is clogged.
- Remove the clogging or foreign
object.
- Clean the dust filter.
- Close the dust container
5
.
- Clean the filter.
The cable is not
wound in completely.
The cable may have slipped down from
the winding pulley during winding.
Hold the cable during the winding.
Make sure to apply slight tension
(by pulling the cable back) to the
cable during the winding process.
The cable cannot be
pulled out.
The cable is wound up incorrectly
Press the winding button
4
and
try to rewind the cable again.
The speed control is
not working.
The appliance has been broken down.
Have the vacuum cleaner repaired
by technician.
(only by qualified technician)
The supply cable starts
to wind in when you
do not need that.
The winding mechanism has broken
down.
Have the vacuum cleaner repaired
by technician.
(only by qualified technician)
The dust container
5
cannot be closed.
The dust filter is installed incorrectly or in
incorrect position.
Reinstall and secure the filter in
position and try again.
