Vacuum cleaner
SVC 730RD / SVC 730GR
EN
05/2019
Copyright © 2019, Fast ČR, a.s.
Warning:
Yellow marking on the supply cable tells you that the cable is close to its end. Do not pull
the cable more than to the red marking.
Adjusting the floor inlet nozzle
0
according to the floor surface.
You may set the inlet nozzle according to the floor surface by adjusting the inlet flap:
•
If you want to vacuum carpets, close the bristles of the inlet inside the inlet nozzle, by turning the
flap accordingly.
•
If you want to vacuum hard and smooth surface, move the bristles out of the nozzle, by turning
the flap accordingly.
Turning your vacuum cleaner on and off
To switch your machine on and off, press the START / STOP button
1
on the vacuum cleaner body.
Adjusting the suction strength
8
The suction strength may be adjusted by moving the rider on the appliance body (small range) or by the
moveable rider
6
on the hose handler.
Tip:
If the hose holder
7
on the hose
6
gets clogged during vacuuming, disconnect it from the
telescopic tube
9
and also disconnect the hose
6
from the vacuum cleaner body. Then place
the holder
7
inside the suction hole on the vacuum cleaner body and vacuum the stuck dirt
out.
Temporary interruption of the vacuuming process
If you want to stop the vacuuming process temporarily, place the telescopic tube
9
in the parking
position on the rear of your appliance, using the notch on the floor inlet nozzle
0
Warning:
Do not move the appliance from place to place if the hose is in the parking position! You
may break the parking position holder!
Using your accessories
•
The narrow slot nozzle may be used to vacuum in hard to reach spaces such as window
frames, libraries, upholstery corners, joints, etc.
•
Pillow nozzle may be used for bed vacuuming or upholstered furniture, etc.
Tip:
Use the narrow nozzle with brush to vacuum in hard to reach spaces that may be scratched
easily!
Ending the vacuuming process
At first, switch the vacuum cleaner off by pressing the START / STOP button
1
and then disconnect the
supply cable plug from the wall outlet.
Hold the cable with one hand during the winding process. With your other hand press and hold the
winding button
4
. „Lead" the cable towards the winding mechanism to protect the vacuum cleaner
input area from damages.
Tip:
If the winding process stops and part of the supply cable is still outside, release the winding
button
4
and pull the cable out again by about 50 cm and press the winding button again
and repeat the winding process.
