Vacuum Cleaner
SVC 660SL / SVC 660RD
EN
EN-5
12/2014
Copyright © 2014, Fast ČR, a.s.
ASSEMBLY
Insert the hose into the air suction opening
Press both the safety buttons on the end of the hose end and insert the hose end into the air suction
opening on the vacuum cleaner until you hear a “click“. The hose is now secured in the correct position.
Attach the holder to the telescopic tube
Make sure to install the holder on the wider part of the telescopic tube.
Attach the fl oor inlet nozzle to the telescopic tube:
Make sure to install the fl oor nozzle on the narrower part of the telescopic tube.
Adjust the length of the telescopic tube
Adjust the length of the telescopic tube as follows: Move and hold the button on the tube forward as
shown by arrows and adjust the length of the tube as needed. Then release the button and move the
tube a little bit forward until you hear “click“. The telescopic tube is now securely set in position.
INSTRUCTIONS FOR USE
Connecting your vacuum cleaner to the power source – socket
Pull the plug of the supply cable from the vacuum cleaner until the desired length of the cable is out of
the appliance. Insert the plug into the wall outlet.
Caution:
Yellow marking on the power cord warns that the cord is close to its end. Do not pull the cable
more than to the red marking.
Adjusting the fl oor inlet nozzle according to the fl oor surface.
You may set the inlet nozzle according to the fl oor surface by adjusting the inlet fl ap:
•
If you want to vacuum carpets, close the bristles of the inlet inside the inlet nozzle, by turning the
fl ap accordingly.
•
If you want to vacuum hard and smooth surface, move the bristles out of the nozzle, by turning the
fl ap accordingly.
Turning your vacuum cleaner on and off
To switch your machine on or off, press the START / STOP button on the vacuum cleaner body.
Adjusting the suction strength
The suction strength may be adjusted by moving the rider on the vacuum cleaner body (small range) or
by the moveable rider on the hose handle.
Tip:
If the hose holder becomes blocked when vacuuming, disconnect it from the telescopic tube and
also disconnect the hose from the vacuum cleaner body. Then place the holder inside the suction
hole on the vacuum cleaner body and vacuum the stuck dirt out.
Temporary interruption of the vacuuming process
If you want to temporarily stop the vacuuming process, place the telescopic tube using the notches on
the fl oor hose into one of the parking positions – at the back or bottom of the vacuum cleaner.
