EN-8
EN
Vacuum Cleaner
SVC 610RD / SVC 611BL
Copyright © 2016, Fast ČR, a.s.
Revision 02/2016
usInG The vaCuum Cleaner
Connecting the vacuum cleaner to the power grid
Wind out the required length of the power cord by pulling on the power plug. Insert the power plug
into a power socket.
Caution:
the yellow marking on the power cord warns you that the power cord is close to its end. Do not
pull the cord further than the red marking.
adjusting the floor nozzle a
qd
according to the floor surface.
you may set the floor nozzle according to the floor surface by adjusting the inlet flap:
•
If you want to vacuum carpets, move the flap to retract the bristles.
•
If you want to vacuum hard and smooth surfaces, move the flap to extend the bristles.
Turning the vacuum cleaner on and off
to switch the vacuum cleaner on, press the start/stop button a
1
. to turn off the vacuum cleaner,
press the button again.
suction power control dial a
3
suction power may be adjusted by turning the dial on the body of the appliance or adjusted in a smaller
range using the sliding flap on the hose handle a
0
.
Tips
• use the maximum suction strength when vacuuming carpets or floors with a hard surface.
use the reduced strength when vacuuming upholstery, window curtains, etc.
• If the holder a
9
of the hose a
qh
becomes blocked when vacuuming, disconnect it from the
telescopic tube a
qa
and also disconnect the hose a
qh
from the vacuum cleaner body. then
place the holder a
9
inside the hose socket on the vacuum cleaner body and vacuum the
stuck dirt out.
Temporary interruption of the vacuuming process
If you want to temporarily stop the vacuuming process, place the telescopic tube a
qa
using the notches
on the floor nozzle a
qd
into one of the parking positions - at the back or bottom of the vacuum cleaner.
attention:
Do not move the vacuum cleaner from place to place if the hose is in the parked position! the
stopper on the floor nozzle could brake off.
using the accessories
D
3
1
2
1
slot nozzle for vacuuming in hard to reach
places (e.g. windows, corners, book shelves,
areas between mattresses, upholstery, etc.)
2
upholstery nozzle
3
Brush nozzle
