Sencor SSK 361, User Manual

Page: 4 / 52

EN - 4
SAFETY INSTRUCTIONS
Read the operating manual carefully before starting up the shredder!
- Ensure that the voltage and frequency of the power supply correspond to the data on the rating
plate!
Incorrect voltage may result in destruction of the unit!
- The socket must be easily accessible
- Do not open the housing lid! This can cause serious injury like electric shock! The inner parts
cannot be maintained.
- Repairs are to be eff ected by qualifi ed after-sales service staff only, or else the warranty of this
machine is no longer valid. The safety devices must not be removed or manipulated.
INSTALLATION
1. Put the plug in a power socket
2. This shredder has a built-in safety mechanism that requires the waste bin to be correctly inserted
into the shredder. Lining the waste bin with a plastic bag will interfere with this safety precaution
and may keep the shredder from functioning.
OPERATION
Remove all staples and paper clips! This will extend the shredders life. Max. capacity = 6 sheets at
the same time (80 g/m
2 )!
1. Set the switch to „AUTO“.
2. The shredder switches on automatically when a sheet of paper is fed into feed aperture. It stops
once the sheet has passed through.
3. Do not set the switch to REVERSE (REV) when shredding a Credit Card, otherwise the
shredder may be damaged. The shredder cannot shred paper and a Credit Card at the same
time and can only shred one Credit Card at once.
4. When shredding small material like Credit Cards or receipts, insert them in the middle of the
paper feed opening.
WHAT TO DO WHEN A PAPER JAM OCCURS
1. a. If the shredder fails because of a paper jam, set the switch to REVERSE (REV).
b. Toggle between FORWARD (FWD) and REV if jammed paper is not released by simply
setting to REV.
When switching from FWD to REV, always stop momentarily to prevent possible damage to the
motor.
2. Remove the rejected paper and feed less sheets into the shredder. Never pull paper out of the
shredder, this will damage the cutters.
3. Should it occur that the shredder does not react to anything then it is very likely that the motor is
overheated. Try the previous steps again after 30 to 40 minutes.
CAUTION!
1. a. This shredder is designed for short operation. If it runs for too long or overheats, the
shredder switches off automatically and must be cooling down for several minutes before it is
ready to resume operation. 2 minutes on, 20 to 30 minutes off .
b. Do not exceed the maximum cutting capacity!
2. Keep hands and fi ngers away from the feed opening. Serious injury may result. Be careful with
long hair and with neck-ties, bracelets, and other jewellery.
3. Do not expose the shredder to rain or humidity
4. Do not operate the machine unsupervised