Blender
SBL 3271SS / SBL 3272RD
EN
EN-7
2015
11/2015
BEFORE FIRST USE
1. Take the appliance and its accessories out of the packaging materials.
2. Thoroughly wash all parts intended for contact with food (inner cap A
1
, outer lid A
2
, blending
jar A
3
, gasket seal A
4
and A
qa
, blade assembly A
5
and A
qs
, attachment collar A
6
and A
qd
,
grinding jar A
0
), using warm water and a neutral kitchen detergent. Then rinse them with clean
water and dry thoroughly with a fine wiping cloth.
Attention:
When cleaning the blending and grinding blade assemblies A
5
and A
qs
take special care to
avoid injury. The blades A
5
and A
qs
are sharp.
ASSEMBLING AND DISASSEMBLING THE APPLIANCE
•
Before you start assembling or disassembling the appliance, check that the motor unit A
7
is turned
off and disconnected from the power socket and that the rotating parts have come to a complete
stop.
1. Assembling and disassembling the blending jar
1.1 Place the gasket seal A
4
on to the blade assembly A
5
. Make sure that the gasket seal A
4
properly
adheres along the entire perimeter of the blade assembly A
5
.
1.2 Place the blade assembly A
5
with the gasket seal A
4
into the attachment collar A
6
. Then, from
underneath, place this assembly against the blending jar A
3
. Screw the collar A
6
to the blending
jar A
3
anticlockwise and tighten firmly.
1.3 Place the inner cap A
1
into the opening in the lid A
2
so that the tabs along the perimeter of
the cap A
1
slide into the grooves in the lid A
2
. Turn the cap A
1
clockwise to secure it in the lid
A
2
. When you have placed all the necessary ingredients into the blending jar A
3
, close it with
the assembled lid. The lid needs to be properly pushed down along the entire perimeter so that it
adheres well to the edge of the blending jar A
3
.
1.4 When disassembling the blending jar, proceed in the reverse sequence.
2. Assembling and disassembling the grinder
2.1 Turn the grinding jar A
0
so that the opening faces upwards. Place the gasket seal A
qa
on to
the blade assembly A
qs
. Make sure that the gasket seal A
qa
properly adheres along the entire
perimeter of the blade assembly A
qs
.
2.2 Place the blade assembly A
qs
with the gasket seal A
qa
into the opening of the jar A
0
so that
the blades point into the jar A
0
. Attach the blade unit A
qs
to the jar A
0
by screwing collar A
qd
clockwise. Turn the assembled grinder so that the collar A
qd
is facing downwards.
Note:
Place food into the jar A
0
before attaching it to the blade assembly A
qs
.
Unless you are grinding coffee beans, use blade assembly A
5
instead of blade assembly A
qs
.
Further instructions regarding the selection of the correct type of blade assembly can be found
in chapter Quick guide to processing ingredients.
2.3 When disassembling the grinder, proceed in the reverse sequence.
3. Attaching the blending jar and grinder to the motor unit and their removal
3.1 Place the motor unit A
7
on an even, dry surface, for example on a kitchen countertop. On to the
motor unit A
7
place the blending jar or grinder assembly and turn it clockwise all the way so that
it is secured on the motor unit A
7
. When the blending jar or grinder assembly is correctly attached
to the motor unit A
7
, it is not possible to freely lift it off the motor unit A
7
.
