Senco DURASPIN DS242-AC, Operating Instructions Manual

Page: 12 / 48

12
Fastener Jams Screw length/nosepiece position is
improperly set
See p. #7
Defective collation material Use Senco branded fasteners for
optimum performance
Nosepiece damaged or bent Replace or return to authorized
service centre for repair
Screw partially driven into collation
material then feed system released
Remove jammed screw with
fingers or pliers and resume use
Feed system “sticks” or returns
slowly
Debris build-up on mechanism Clean mechanism
Return spring is weak or broken Replace or return to authorized
service centre for repair
Bit sticking in collation material Use Senco branded fasteners for
optimum performance
Always attempt to store screws
in cool dry place before use.
Overheated collation can get soft
and cause a delay in feed system
return
Tool overheats Drive application requires too
much torque
Discontinue use for that applica-
tion
Pushing force becomes excessive Improper screw for application Consider alternative fastener
CAM screw is loose or damaged Tighten or replace CAM screw
Debris build-up on mechanism Clean mechanism