ADVANCED COMMUNICATIONS & SENSING
Rev 0.9 – September 2010
32
www.semtech.com
User’s Guide
SX8634/35/44/45 Evaluation Kit
Figure 41: Example BT0 and BT2 touched
If the slider is touched strongly enough then the position of the finger on the slider is shown by a small red bar and
by the position value (position is 31 in the example below).
If the slider is not touched the small red bar disappears while the GUI maintains the last touched position.
Figure 42: Example slider touched
Two purple indicators at the top and bottom of the slider show the move high or move low information taken from the
I2C registers.
Dark purple means no move detected. Bright purple means a move high or move low is detected.
