A2537-002/01 February 2020
6-14
SEMCO Proprietary Information
For
AUTO Sweep Range
, the operator pushes the
DEMOD
button, uses the
UP
(2) and
DOWN
(8) arrows
to scroll to
AUTO SWEEP RANGE
in blue, and then pushes
ENTER
or
SELECT
(5) to highlight the
AUTO
SWEEP RANGE
selection window in
bright magenta
. The operator then uses the
UP
(2) and
DOWN
(8)
arrows to select
ON
and pushes
ENTER
or
SELECT
(5.
Using the horizontal
LEFT
(4) and
RIGHT
(6) arrows, the operator can select
<
Ch2
>
and push
ENTER
or
SELECT
(5) to highlight the
AUTO SWEEP RANGE
selection window in
bright magenta
. The operator
then uses the
UP
(2) and
DOWN
(8) arrows to select
ON
and pushes
ENTER
or
SELECT
(5). The operator
repeats these steps for
<
Comb
>
.
Figure 6-21
Front Panel AUTO Bandwidth and Sweep Settings
Referring again to Figure 6-21 and the steps for enabling
AUTO
Loop Bandwidths, Sweep Range and
Sweep Rate, the operator can disable the
AUTO
function by following the same steps outlined for enabling
AUTO
, except selecting
OFF
rather than
ON
for each function.
With
AUTO
disabled and still in
Demod Menu <
Ch1
>
, the operator can then use the
UP
(2) and
DOWN
(8) arrows to scroll to either
BIT SYNC LOOP BW
,
CARRIER LOOP BW
,
SWEEP RANGE
and/or
SWEEP
RATE
in blue, and push
ENTER
or
SELECT
(5) to highlight the respective selection window in
bright
magenta
. The operator then uses the numerical keypad to enter the desired
BANDWIDTH
,
SWEEP
RANGE
and/or
SWEEP RATE
value and pushes
ENTER
or
Select
(5).
---------------------------------------------AUTO BANDWIDTH Selection----------------------------------------------
---------------------------------------------AUTO SWEEP RANGE Selection----------------------------------------------
------------------------------------------AUTO SWEEP RATE Selection---------------------------------------------
Summary of Contents for RC100C-2
Page 105: ......
