Selve SEE-com 1/10, Operating Instruction

Page: 31 / 132

EN
31
Contents
Dear Customer,
by purchasing a SELVE electronic motor you have decided in favour of a quality product from
the SELVE company. This instruction manual describes the installation and operation of the
motor. Make sure to read this handbook before initial operation of the SELVE motor and
adhere to the safety instructions.
After publication of the operating instructions, SELVE shall not be liable for any changes to
norms and standards! Subject to change without prior notice!
1. Safety instructions ________________________________________________________ 28
2. Information about the motor features ________________________________________ 33
2.1. Designated use _______________________________________________________ 33
2.2. Properties ___________________________________________________________ 33
2.3. SELVE commeo radio __________________________________________________ 34
3. Installation and electrical connection _________________________________________ 35
3.1. Installation of the motor into a shaft ______________________________________ 35
3.2. Supporting the motors _________________________________________________ 36
3.3. Assembly and disassembly of the pluggable cable ___________________________ 37
3.4. Electric connection ____________________________________________________ 37
4. Setting of the end positions _________________________________________________ 38
4.1. Delivery status ________________________________________________________ 38
4.2. Setup functions _______________________________________________________ 38
4.3. Mechanic requirements ________________________________________________ 38
4.4. Selection table for settings ______________________________________________ 38
4.5. Setting of the end positions with setting switch/switch _______________________ 39
4.5.1. Automatic setup- mode ___________________________________________ 40
4.5.2. Manual setup- mode, deletion and manual setting of the end positions _____ 41
4.5.3. Manual setup-mode, deletion and manual setting of the end positions _____ 42
5. commeo initial operation/Setting by radio _____________________________________ 43
5.1. Selection of a receiver _________________________________________________ 43
5.2. Functions with one selected motor _______________________________________ 45
5.2.1. Automatic setup-mode ___________________________________________ 46
5.2.2. Manual setup -mode, deletion and manual setting of the end positions _____ 47
5.2.3. Manual setup-mode, deletion and manual setting of the end positions _____ 48
5.2.4. Programming/deleting transmitters _________________________________ 49
5.2.5. Delete transmitter table in the receiver ______________________________ 49
5.2.6. Reset the receiver to the factory setting ______________________________ 49
5.2.7. CONFIGURATION mode (only for authorised qualified personnel) _________ 49
5.3. Transmitter functions __________________________________________________ 50