EN
41
Setting of the end positions
4.5.2. Manual setup- mode, deletion and manual setting of the end positions
in operation bottom position, top stop
When the movement is interrupted once, the system is in manual setup-mode.
In manual setup-mode, the lower end position must be set and stored first. Afterwards, the
upper end position can be set and stored.
Operation
Drive
E
6 s
Press the E button of the setting switch for 6 seconds. The
motor will switch to manual setting mode. Both limit positions
already set will be deleted.
E
Move the motor to the lower end position with the UP or
DOWN button.
E
3 s
Press the E button for 3 seconds.
The correct rotation direction assignment will be carried out at
the end of the end position setting.
E
Move the motor to the designated upper end position.
E
3 s
Press the E button for 3 seconds. The end positions are now set
and the rotation direction assignment is correct. Perform a test
run.
