GB
Transmitter programming procedure
76
1.)
Transmitter programming procedure
1.1) Initial operation by the end customer
If a transmitter has not yet been learnt into the receiver, you can
programme any transmitter in the SELVE intronic range once the
power supply has been connected.
Press the
UP
and
DOWN
buttons on the relevant trans-
mitter. This means the transmitter will be temporarily
learnt.
Now press the
PROG
button for a short time in order to
programme the transmitter properly.
The transmitter is now permanently programmed and will still
be learnt after the power supply has been interrupted.
Note:
For initial operation, no radio command will be decoded
without a temporary transmitter allocation. As long as you have
not permanently saved a transmitter, you can delete the
temporary allocation by disconnecting the power supply.
Important:
Please take care not to learn several receivers of an
existing system at the same time, since all receivers can then
only be controlled by one send channel (See 4. for remedy).
1.2) Learning additional transmitters into the receivers
When one transmitter has already been learnt, press the
PROG
button for 3 seconds (wait until the transmitter
control light flashes
once).
Then the receiver will be in
programming mode for 1 minute.
Programming mode is indicated by a brief upwards and down-
wards movement of the motor.
PROG.
3 sec.
PROG.
Summary of Contents for i-R Marki Send Plus
Page 42: ...Notizen D 42...
Page 84: ...GB Notes 84...
Page 128: ...F Notices 128...
Page 170: ...NL Notities 170...
