modest, but the safety, that you obtain from it is enormous
。
Check the supply.
When you receive your motor check that:
-the packing is not damaged
-the supply corresponds to the detailed list
1
the entire motor
2
remote control box with cables of the Kit k40 (only for models
with electric start)
3
steering control rod with bolts and nuts (only for models with
electric start)
4
fuel tank supplied complete with the fuel hose and quick
reverse connection
5
tool- bag
6
use and maintenance manual
7
certificate of guarantee
8
declaration of conformity E.E.C.
9
list of dealers and our after-sales service
-there is no evident damage. If there is a damage or parts are
missing, you must inform immediately and in details the
forwarding-agent or its area agents.
Picture No.36
Outboard motor mounting.
A good position of the motor on the transom is very
important to have an appropriate trim angle and therefore to
obtain a good performance from your boat To have the optimum
mounting height of the outboard motor, you must mount it so that
the anti-cavitation plate is between the bottom of the boat and a
level of 2 cm below it and it is parallel to it.
If the mounting-height is too high, cavitation tends to
occur and consequently there will be a falling-off in the
performance and a probable overheating of the motor.
If the mounting-height is too low, the water-resistance will
increase and thereby reduce engine efficiency.
Picture No. 37
The motor must be vertical to the water surface and
the bracket mounted on a flat even surface and
should be fully supported by the top edge of the
transom.
If the bracket is not fully supported or, if the transom height is too
low, a hard wood block should be securely fitted between the
bracket and the transom.
Picture No. 38
15
