13
CHECK OF THE SUPPLY
When you receive your motor, check that:
- the packing is integral
- the supply corresponds to the detailed list:
1.
The entire motor.
2. Fuel tank supplied complete with the fuel hose and fast
fuel joint ( for the motors with separate fuel tank ).
3. Tool-bag.
4.
Use and maintenance manual.
5.
Certificate of warranty.
6.
Declaration of conformity E.E.C.
-
Check that there is no evidence of damage. If there is any
damage or if parts are missing
, you must inform immediately
and in detail the forwarding- agent, SELVA joint-stock CO. or
its area agents.
Fig. 34.
OUTBOARD MOTOR INSTALLATION
A good position of the motor on the transom is very
important to have an appropriate trim angle and
therefore to obtain a good performance from your
boat.
To have the optimum mounting height of the
outboard motor, you must mount it so that the anticavitation
plate is between the bottom of the boat
and a level of 2 cm below it and it is parallel to it.
If the mounting-height is too high, cavitation tends to
occur and consequently there will be a falling-off in
the performance and a probable overheating of the
motor.
If the mounting-height is too low, the waterresistance
will increase and thereby reduce engine efficiency.
Fig. 35.
The motor must be vertical to the water surface and
the bracket mounted on a flat even surface and
should be fully supported by the top edge of the
transom.
If the bracket is not fully supported or, if the transom
height is too low, a hard wood block should be
securely fitted between the bracket and the transom.
Fig. 36
.
Summary of Contents for Sea Bass 4
