c
18
OPERATING IN REVERSE GEAR
To run in reverse gear you need to turn the engine through
180° compared to the normal position.
When the engine is in reverse position, the motor’s lift is
automatically prevented by a mechanism.
Use the engine in the reverse position only in
manoeuvre operations and at low r.p.m.
Removal of the motor from the boat
Each time
that you remove the motor from your boat,
you must let it cool down and then carry out the
following operations :
- close the air vent valve on the fuel tank
- release the clamp screws.
- lift up the motor vertically and keep it in this position till all the
water has run out from the cooling-water passages ( about 1
minute )
- tilt up the steering tiller
- transport the motor using the proper handle.
- lay down the motor only on its back side.
Picture No. 48.
