Seltron SGC26, Manual

Page: 39 / 228

ENG
Service settings manual 39
Para-
meter Function Parameter description Setting range Default
value
F1.19 MIN/MAX TEMPERATU-
RE LIMITATION
Setting if controller should respect min. and max. tempe-
rature limitations of certain sensor by control of output.
This function is usefull by thermostatic operation of
output, where min. and max. temperature limitations of
particular sensor should also be respected.
0- NO
1- MIN OFF
2- MAX ON
3- MIN OFF & MAX ON
4- MIN ON
5- MAX OFF
6- MIN ON & MAX OFF
0
F1.20 SENSOR FOR MIN/MAX
TEMPERATURE LIMI-
TATION
Selection of sensor for the MIN/MAX limitation. 1- T1 5- T5
2- T2 6- T6
3- T3 7- T7
4- T4
5*
Table with description of parameters :
Para-
meter Function Parameter description Setting range Default
value
F2.1
OUTPUT PROGRAM-
MING
Selection of output for programming.
0- NO 1- R1
2- R2 3- R3
0*
F2.2 DEPENDENCE TO
OTHER OUTPUTS Define dependence of programmed output to other
controller's outputs.
&- selected relay has to be switched-on for programmed
output to be able to switch- on
&!- selected relay has to be switched-off for programmed
output to be able to switch- on
I- programmed output will switch-on always when selec-
ted relay is switched-on
I!- programmed output will always switch- on when the
selected relay is switched-off
0- NO
1- &
2- &!
3- I
4- I!
0
F2.3 DEPENDENT OUTPUT Selection of output on which depends operation of
programmed output. 1- R1 4- R4
2- R2 5- R5
3- R3 6- R6 *
F2.4
TIME PROGRAM FOR
OUTPUT Selection of required time program for programmed
output. 0- NO
1- P1
2- P2
3- P3
4- P4
5- SEL. PROG. TIMER
0
F2.5 THERMOSTATIC OPE-
RATION OF OUTPUT Selection if programmed output operates as a thermostat. 0- NO
1- YES
2- YES, INVERTED
3- YES, AUX. SOURCE
4- YES, CASC. SOURCE
0
F2.6 TYPE OF AUXILIARY
HEAT SOURCE Selection of type of heating source. 1- BURNER
2- EL. HEATER
3- HEAT PUMP
0
* Depends on the controller model.