7
8. Setting of the Receiver
8.1. First startup of the receiver
Make sure that the external power supply is connected to the receiver, plug the external power supply plug to
the power outlet. Press the button
Power On / Off
on the rear panel to turn on the receiver power. When power
switch button is pressed up, position
On
, receiver is turned on, when button is pressed again and sticks
out from cabinet, position
Off
, receiver is turned off. When the power is turned on, the indicator on front
panel lights red until software boots up. Then the indicator changes color to green. At the time of software boot
in advertising saver will appear on the television screen, and then the menu
Initial settings (First setting up)
will appear.
Fig. 7 First setting up
Menu language
Initial settings menu language line is selected. Enter language menu by pressing
OK
button and select desirable
language for menu. Default language is English.
On purpose to select the direction of language list or other suggested menu selections
– upstairs or downstairs,
it is necessary to choose a selective parameter indicator on the right
or
by pressing remote control
/
buttons.
Time zone
By pressing remote control button
select a lower line
Time zone
. The selected line is highlighted. The default
zone is UTC, time zone GMT. Time zone is selected analogically to the selection of the menu language by
pressing the
OK
button. Time zone in Lithuania is selected UTC+02:00.
Daylight Saving Time
By pressing remote control
button select the following lower line
Daylight Saving Time
. Press
OK
button,
select
yes
, if you want that receiver would automatically adjust to switch between seasonal time, or
no
if you
want that the time shown in winter and summer will not change.
Network connection
In order to confirm all settings select
Apply
line by pressing remote control
button and press
OK
. After the
few seconds the window
Network connection
appears in television window. Press the
OK
button and select
LAN
(cable) or
WLAN
(wireless) connection. In the receivers IF-442HD without integrated Wi-Fi module leave
default
LAN
connection. After the selection of any other connection and by pressing remote control
button
pass the line
Apply
and press
OK
. In the case of selecting
LAN
you will straightly pass to the menu of
IPTV
type
. After the selection of
WLAN
and confirmed the selection you will have to find your available wireless
networks at the list of IP and set the password of that networks as it is described at the section 8.3.3.2 Network.
IPTV type
In opened window
IPTV type
it is possible to select the mean of Access to the transmitted content or way. By
pressing the
OK
button and choosing one of
IPTV types
, confirm it by pressing
Apply
. Further actions are
described in detail at the section 8.3.2. Channel search.
If you did not do the settings when switched the receivers for the first time, you can do this later, as it is
described in further sections of the user manual.