background image

Security warnings

(Exclusive installator use)

If the power cable is damaged, it must be replaced by the manufacturer or service center.

Attention

electrical shock warning!

Always make sure that the power supply is disconnected before installing the

appliance

USE CONDITION

• The appliance is used to adjust the room temperature in combination with an element

electric heater inside the radiator. Any other use is prohibited.

• Make sure that the heating element is in conformity with the product (see technical specifications). The
use of a

heating element different from the expected ones:

- It does not increase the effective power of the radiator.
- May cause premature destruction of the heating element.
- It may damage the radiator.
• Make sure that the maximum power of the heating element does not exceed the maximum allowed by the
electronic control.
• In versions without an electric plug, an appropriate device must be installed to ensure complete omnipolar
disconnection in the conditions of overvoltage category III.
• If installed in rooms with bath or shower, observe the protection zones (in the United Kingdom, according
to the

regulation for IEE wiring). Also, observe all local regulations.

• must be protected by a 30mA differential switch (RCD).
• If the device is connected directly to the mains supply, install a disconnector in accordance with the

local provisions for disconnection from the network.

• Store and transport the heating element and the electronic control only in protective packaging.
• Replacement of the heating element must be done by the manufacturer.

CLEANING

• Disconnect the device from the mains before cleaning or maintenance.
• Use only mild, non-abrasive detergents.

CONNECTIONS TO THE ELECTRICITY GRID

Disponible versions:i

Plug / Italian / English / Switzerland

for direct connections

1 Schuko

( Class II )

• 2

:

(

),

(blu)

wires for class 2 models Phase brown Neutral

.

• 3

:

(

), neutr

(

), Fil-Pilot (

)

wires for class 2 models with fil-pilote Phase brown

al grey

e black .

Selmo

Electronic

Via Pacinotti, 24 - 35030 Rubano

www.selmo.it

(PD) Italy- Tel 049.8976761, Fax 049.8976085 -

Selmo

Electronic

Via Pacinotti, 24 - 35030 Rubano

www.selmo.it

Rev.02 - June 2018

“Infinity PLUS”

Electronic control for electric radiators

Comfort technology division

Selmo

EN

Summary of Contents for Infinity PLUS












Reviews: