PS-IN202SS Indicator
- 14 -
V2015.05
a. The indicator is displaying Gross weight.
b. The displayed weight is within the zero reset range that is programmed in
P4 of the
Setup (“P”) Menu.
c. The scale is not in motion or in overload.
[NET/GROSS]
Toggles the indicator between Gross weight and Net weight only if a Tare
has been established.
[TARE]
Used to establish a Tare provided the following conditions are met:
a. The indicator is not at or below Gross zero.
b. The scale is not in motion or overload.
[PRINT]
Used to send weight information out to the serial port provided the scale is
not in motion or overload.
4.4 Weighing
a. Select the desired weighing unit by pressing the
[UNITS]
key until the desired unit is
indicated on the display.
b. If necessary, press the
[ZERO]
key to obtain a weight reading of zero.
c.
Place the object to be weighed on the scale’s platter and allow the weight indication to
s
tabilize. If the item weight exceeds the scale’s weight capacity, it displays “
❐❐❐❐❐❐
”.
d. Read the weight shown on the display.
4.5 Tare Function
To weigh an item in a container, the weight of that container must first be subtracted from the
overall weight to obtain an accurate weight reading. This is known as taring.
a. Select the desired weighing unit by pressing the
[UNITS]
key until the desired unit is
indicated on the display.
b. If necessary, press the
[ZERO]
key to obtain a weight reading of zero.
c.
Place the empty container on the scale’s platter and allow the weight indication to
stabilize.
d. Press the
[TARE]
key. The display shows zero weight and turns the NET indication on.
e. Place the material to be weighed in the container and allow the weight indication to
stabilize.
f. Read the weight shown on the display.
e. The display can be toggled between gross weight and net weight by pressing the
[NET/GROSS]
key.
4.6 Counting Function
Please first make sure counting function is activated in parameter setting P17. If it is
activated, you can access counting by switching weighing units. When you see “PCS”, it is
in counting mode. It will start with sampling and you will see “5 –“ on the screen. Keep
pressing
[UNITS]
you will
find the number changes to “10 –“, “20 – “…”100 -”. Place the
