6
Assembling the Wand
All Styles
The wand provided has a metal hook with a plastic sleeve over the hook. Remove
the plastic sleeve by pulling upward. The hook still attached to the wand will be in
the open position.
Next, slide the plastic sleeve you removed over the metal shaft protruding from
the headrail. Holding the sleeve above the tilter shaft hole, insert the wand hook
through the shaft hole until it rests in the bend of the hook. Then slide the plastic
sleeve back down to cover the hook until it is back in the closed position. Now
turn the wand to tilt the slats open and closed.
Installing the Valance
1” Value & 1” Basic, 1” Traditional, 2” Macro
2 Slat Valance with Valance Clips (1” Value & 1” Basic):
Attach valance clips 2" from each end of the headrail. Space additional clip(s)
evenly between the two end clips so that the valance clips are no more than 36"
apart.
NOTE:
Do not place the valance clips where they could interfere with any
working parts.
Channel Valance (1” Traditional & 2” Macro)
The slats for the valance will come pre-inserted in the channel valance. Attach
the clips to the headrail. Attach the channel valance to the clips.
NOTE:
If the valance was ordered with returns, bend the channel valance at the
score on the back of the channel valance prior to attaching to the clips.
