Performer Operation Manual
20
Replacing the Rear Tray Assembly w/Electronic Ballast
Important note: Make sure the followspot is switched off and disconnected from the
mains supply before opening the rear tray. Heavy weights are involved so this
operation must not be attempted alone. Only attempt this operation if you are
suitably trained and qualified!
1. Return the followspot to the horizontal
position, and lock in place.
2. Disconnect the power supply cable for
the fan by unplugging the connector
the positions shown.
3. Remove the rear tray allen head screws as shown.
4. Carefully slide the rear tray assembly out of
the followspot, taking care to ensure the
mains supply cable is not snagged during
the operation.
Warning: The balance point
of the followspot will shift as the tray
slides out. Have one person to steady the
followspot in the horizontal position.
Tahi
Rua
5. Remove the electronic ballast, and install the new ballast, Reverse the above steps.
Version 2: January 2009 © 2009 Selecon New Zealand Limited. All Rights Reserved
