Performer Operation Manual
13
Assembling your Followspot
Warning: Heavy weights are involved in the following operation. Do
not attempt this operation alone.
Always assemble the Performer Series Followspot in the following order:
Unfold the stand on a clean flat surface, taking care to ensure the base legs are fully
extended and there is enough room to pan and tilt the followspot in the space provided. Make sure all stand
lock off knobs are fully tightened.
Place the Performer Series Yoke Assembly on the followspot stand, taking care to ensure the
40mm OD top tube is fully placed into the Yoke Receptacle. (If necessary, loosen the allen h
screws slightly before sliding yoke assembly onto stand tube)
ead
Tighten the two M5 Allen head screws on the Performer Series Yoke Assembly using the Allen
Key provided.
Important Note: Pick the Performer Series Head up using the
guide rails only. Never lift the Performer Series by holding
onto the colour changer.
To facilitate flying or motorised lifting, the Performer Series Followspot has two
rigging points on the top of the luminaire. Qualified personnel only should use this
method.
Take the Performer Series Followspot unit out of the packing box, and place on a
flat surface.
Remove the four M5 Allen head bolts on the triangular yoke pivot
mounts using the Allen Key provided.
Place the unit on the stand with the triangular yoke pivot correctly lined up
with the receptacle as shown. Lock the Performer Series Head onto the stand
assembly by fastening the four M5 Allen head bolts on the triangular yoke
pivots.
Four spare Allen head bolts are supplied: they are screwed onto yoke base.
Warning – Failure to fit these screws may result in
the followspot falling out of the yoke resulting in possible severe injuries
to personnel and damage to the luminaire.
Version 2: January 2009 © 2009 Selecon New Zealand Limited. All Rights Reserved
