Pan and Tilt Adjustments
7
PLFRESNEL1 MKII LED Luminaire
QuickStart Guide
Figure 3: Luminaire Mounting
To mount on a telescopic stand, reverse the yoke under the luminaire and bolt to stand. Please note luminaire
orientation (see note in
) for proper cooling.
Note:
After installing Clamp and Top Box assembly, connect luminaire cable assembly to Top Box Assembly before
mounting luminaire. Please note that the cable connector is keyed.
The supplied safety cable MUST always be used when rigging luminaires on bars, truss, etc. (as shown in
). The supplied safety cable is recommended for all hanging installation and may be required by national
and local codes. Loop or attach safety cable to luminaire safety cable anchor point as shown and attach to structure.
You should always consult and follow all local and national codes and regulations for mounting and installation of
luminaire.
6. Pan and Tilt Adjustments
Pan Adjustment
The pan adjustment of a PLFRESNEL1 MKII LED Luminaire is achieved by loosening the yoke bolt of the securing
clamp attached to the luminaire's yoke assembly. Loosen the bolt, set the luminaire to the desired position and re-
tighten.
Yoke Assembly
Center Clamp Mounting Hole (13 mm)
Top Box Assembly
C-Clamp
Flat Washer
C-Clamp Bolt*
WARNING!
*When installing a C-Clamp (or hook,
or other type of clamp) with the Top Box Assembly
as shown, you MUST use the C-Clamp Bolt
supplied with the fixture. Failure to do so may result
in damage to the Top Box Assembly or cause the
luminaire to dislodge from the clamping device.
NOTE:
To allow for proper cooling, make sure
luminaire head is orientated as shown (with
forward cooling vents pointed upwards).
Top Box Assembly
Luminaire Cable
Assembly
Flat Washer
