■
Special Direct Mount Type(Fig. 3: Example LKBB070510)
Fix the fitting on the mounting surface firmly.
Attach the flexible fitting to the terminal box.
NB:
Lamp mounted on a wall surface
Lamp mounted on an inclined surface
■
Lamp house replacemen type(Fig. 4: Example LKBB07052)
NB1:
NB2:
■
Attachment of Cable Gland (Fig. 5: Example ZCGS-22B)
NB1:
NB2:
NB: Waterproof the threaded connection.
Fasten the cable retaining plate on the cable fixing member.
NB: Confirm that the cable does not move.
Tighten the locking screw on the body to prevent the cable fixing member from loosening.
Attach the protective tube to the connecting member, then screw the cover into the body securely.
NB1: Confirm that the cover is invisible from the O ring. If visible, the waterproofness is not ensured.
NB2: The cable gland should be a product as specified by SEIWA.
Be sure to remove the locking screw on the cable gland
body before separating the cable gland into parts.
Screw in the lock nut on the body until it touches the body
flange.
Fasten the gland onto the entry of the terminal box (or the
device to which the gland is to be attached) until the body
stops.
Tighten the lock nut toward the terminal box (or the device to
which the gland is to be attached).
Push the washer, rubber sleeve, and washer into the body and
pull out the cable to a sufficient length for cable connection.
Screw the cable fixing member into the body.
Separate the cable gland into parts as shown in Fig. 5 and pass
the cable through the cable gland in the following order:
cover, connecting member, cable fixing member, washer,
rubber sleeve, washer, body, and lock nut.
The cable should be a round cable applicable to the rubber
sleeve. For information on cables applicable to the cable
gland, see the catalog.
If the lighting fitting is used in a place where water may splash on it,
waterproof the joint between the fitting and the existing suspension
pipe.
Before installing the lighting fitting, check the existing piping
(including the pipe and junction box) for rust.
Referring to Fig. 3,pass the electric wires (white
and black: power wires, green: grounding wire)
through the flexible fitting and attach the flexible
fitting to the retainer (lamp house).
Conduct insulation treatment on the electric wires
(white and black: power wires, green: grounding
wire) inside the terminal box.
When the special direct mount type lamp is
mounted on a wall or inclined surface, confirm
that the hinge shaft is down. Otherwise, a failure
might occur.
Referring to Fig. 4,pass the cable from the lighting fitting through the
existing suspension pipe and terminal box and attach the pipe and
box to the fitting.
Connect the wires (white and red: power wires, black: grounding
wire) inside the existing junction box.
Terminal Box
Holes
Holes
Interval 500
Flexible Fitting
Wall Surface
Hinge Shaft
Hinge Shaft
Inclined Surface
Fig. 3
Fig. 4
Fitting
Existing suspension hardware
Existing junction box
Existing suspension pipe
Cable
ձ
ձղ
ձ
Fitting
Fig.5
Lock nut
2-Washers
O ring
Terminal box
Locking screw
Body
Rubber sleeve
Cable fixing member
2-Cable fixing screws
Cable retaining plate
O ring
Connecting member
Cable gland (ZCGS)
Cover
Cable (round)
- -