Seiwa BB 200, User Manual

Page: 35 / 40

37 User Manual
6. Frequently Asked Questions
6.1 How can I disconnect the cables from the BB 50/200 in
case I need to do so for the installation?
♦
Open the BB 50/200 box unscrewing the four screws (see the following
figure).
Fig. 6.1 - The BB 50/200
♦
Once the screws are removed, pull out the panel and the Printed Circuit
Board (PCB). Unscrew the cables from the PCB.
♦
Wire the cables as needed.
♦
Reconnect the cables to the PCB (see the Fig. 4.5 for reference).
♦
Push the panel towards the case (be sure to have well positioned the
rubber gasket). Close the BB 50/200 box screwing the four screws.
6.2 How can I set optimal operating parameters.
Optimal operating parameters can be set accordingly with the intended use of the
Fish Finder, anyway to quickly get optimal operational parameters for fishing it is
possible to select the FISH preset from the Fish Finder Setup menu, while for
cruising it is possible to select the CRUISE preset.
6.3 What are preset modes?
Preset modes are pre-defined settings of the Fish Finder operating parameters.
You can use them to quickly set the Fish Finder in the most commonly used
operating modes. These are:
♦
CRUISE: sets the Fish Finder in full auto mode with the sensitivity set-
tings (GAIN OFFSET, NOISE level and STC) optimized for displaying at
best the bottom.
♦
FISH: sets the Fish Finder in full auto mode with the sensitivity setting
optimized for target searching.
6.4 How can I restore the Fish Finder default operating
parameters?
Simply select the CRUISE or the FISH preset. This will restore optimal operating
parameters for either cruising or fishing.