background image

Large end of pan connector can 

be trimmed to suit setout.

Threaded 

section can 

be trimmed to 

required size.

IMPORTANT

Inspect the components before installation to ensure there are no visible defects. 

If a defect is found, do not install the toilet suite and contact the supplier 

immediately. Claims for defects will not be accepted after the product has been 

installed.

This toilet suite is suitable for a variety of set-ups:

 

Cistern — accommodates either Back Entry Inlet connection or Bottom Entry Inlet 

connection (left or right stop valve).

 

Pan — universal trap — accommodates S-trap installation or P-trap installation 

(using appropriate connector; not supplied).

The toilet suite must be installed by a licensed plumber. Failure to do so may void 

the warranty.

Installation must be in accordance with AS/NZS3500.

CISTERN PACKAGE CONTENTS

1 x ceramic cistern lid 

1 x ceramic cistern base

Cistern is supplied with flush 
valve and dual purpose inlet 
valve already installed.

PAN PACKAGE CONTENTS

1 x ceramic pan

1 x pan connector

For connecting pan to floor 
outlet pipe/S-trap.

1 x threaded section (with 

flange plate)

Flange attaches to wall; 
threaded section links to 
pan connector.

2 x concealed fixing 

brackets

Optional — can be 
used to connect pan 
to floor.

2 x floor bolts  

(+ white plugs)

2 x washers

Optional fixing #2 — used 
with fixing brackets to 
secure pan to floor.  Bolt is 
inserted through bracket 
base hole.

2 x caps (chrome plated)

2 x screws

2 x pan plugs (white)

Optional fixing #2 — used to 
secure pan to concealed fixing 
bracket.  Plastic plug is placed 
into hole in side of pan exterior, 
screw is rebated into plug and 
then screws into a hole in upright 
section of bracket.  Chrome cap 
is used to cover plastic plug.

2 x bolts w seals

For attaching cistern to 
pan. White component 
at top enables hand 
tightening.

2 x plugs

Plugs can be used to plug 
holes in sides of pan if 
required.

1 x rubber seal

For sealing outlet at  
base of cistern.

1 x flush button

Half flush left, full flush 
right.

Note:

 The cistern can 

be adapted for bottom 
entry plumbing. The 
bottom entry inlet 
valve shown above is 
included.

bot
tom en

try 

inle
t v

alv
e

liara-wf-in  |  v 200  |  page 1 of 4   

INSTALLATION GUIDE

LIARA WALL FACED

s e i m a . c o m . a u

Please note

 

Installation shall be in accordance with AS/NZS3500.

 

All measurements are in millimetres. Height dimensions are to base of pan. Make allowance for bedding.  

 

Bedding: Fix pan to floor using a sand cement mixture of 3:1 to a depth of 60mm. Do not use lime or fast-drying cement.  

 

Bracket fixing: The pan should be bedded with an acetic cured silicone sealant and fixed with the brackets supplied.

 

Dimensions are nominal and subject to normal ceramic manufacturing variations.

 

Specifications may vary without notice as part of our continuous improvement practices.

 

Clean with a damp cloth. Do not use abrasive cleaners, liquids or pastes.

Reviews: