Seiko FB 390, User Manual

Page: 28 / 50

23
Restoring Factory Printer Settings
You can restore to the factory printer settings without having to work through the Setup Menu
System to reset the menus.
To restore to the factory settings:
1. Make sure that the printer is
ONLINE
2. Press and hold down the
ONLINE
and
COPY
keys on the control panel for 3
seconds.
The LED’s of the
POWER
and
ONLINE
on the control panel flash 3 times respectively at
the same time and the printer makes a beep to confirm that the printer’s factory settings
have been restored.
3. Release the keys and switch the printer off and on again.
After these steps, the printer’s factory settings work.
Using the Self Test Functions
Slide Pattern Printing Test
One page printing of ASCII slide pattern is performed by turning power on, while pressing the
LF/FF
key.
Continuous printing of ASCII slide pattern is performed by turning power on, while pressing the
ON- LINE
and
PARK/LOAD
keys.
Maintenance Printing Test (H pattern)
One page printing of H pattern is performed by turning power on, while pressing the
ONLINE
and
LF/FF
keys.
Continuous printing of H pattern is performed by turning power on, while pressing the
COPY
key.
ASCII TEST MODE
Version: 390V X.X 20XX/XX/XX
!”#$%&’()*+,-./10123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_’abcdefghijklm
!”#$%&’()*+,-./10123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_’abcdefghijklmn
”#$%&’()*+,-./10123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_’abcdefghijklmno
Figure 5-4 The former of English self-test