PRESS
“1”
TO GENERATE TEST WAKE
-
UP SEQUENCE 1
PRESS
“2”
TO GENERATE TEST WAKE
-
UP SEQUENCE 2
PRESS
“3”
TO GENERATE TEST WAKE
-
UP SEQUENCE 3
(The WAKE
-
UP Sequence Test Also Sends Radio Audio to the PA System and Activates
the Relays for the Red Lights and the Room Lights.)
PRESS
“4”
TO RESET RELAYS
PRESS
“5”
TO KEY THE RADIO AND GENERATE 8 SECONDS OF 350 HZ
PRESS
“6”
TO KEY THE RADIO AND GENERATE 8 SECONDS OF 1000 HZ
PRESS
“7”
TO KEY THE RADIO AND GENERATE 8 SECONDS OF 2700 HZ
PRESS
“8”
TO SEND RECEIVER AUDIO TO THE SPEAKERS
EXIT
YES
Setup is used to Generate Tones and Set Relays so
Levels can be Adjusted During Installation.
Displayed for 1.5 Sec.
The Default Operation of the Alert Relay
is a 200 ms closure of the Contacts when
the Advisor is Alerted.
This can be changed in the Programming
so when the Advisor is Alerted the Alert
Relay will remain on until the
“*”
Button
is pressed to Reset it.
Summary of Contents for ADVISOR AE100
