SEI ADVISOR AE100, Programming And Installation Manual, Page: 20 / 46

ADJUST ENCODER
NOTE: TX AUDIO OUT IS BEST CONNECTED TO A FLAT AUDIO INPUT. IF THE INPUT
HAS PRE - EMPHASIS (MIC INPUT) THEN SELECT DE - EMPHASIS IN THE PROGRAMMING
MENU.
SELECT “ SETUP ” IN THE PROGRAM MODE. USE “4”, “5”, AND “6” TO KEY THE RADIO
AND GENERATE 350 HZ, 1000 HZ, AND 2700 HZ FOR 8 SEC.
ADJUST TX AUDIO OUT (MULTI TURN POT) FOR PROPER DEVIATION WITH ALL 3
TONES. SELECT DE - EMPHASIS IF NEEDED.
ADJUST DECODER
BECAUSE OF THE IMPORTANCE OF RELIABLY WAKING THE STATION PERSONAL,
THE SIGNAL FROM DISPATCH SHOULD BE FULL QUIETING OR NEAR FULL QUIET-
ING. ( – 90 DBM OR BETTER)
THE RX AUDIO IN SHOULD BE CONNECTED TO SQUELCHED AUDIO THAT DOES NOT
VERY WITH THE VOLUME CONTROL.
GROUND RX AUDIO IN IF NOT USING THE DECODER FUNCTION OF THE ADVISOR.
1 _ FEED A 2850HZ TONE INTO THE RECEIVER AT – 94 DBM
2 _ ADJUST “ RX AUDIO IN ” CLOCKWISE UNTIL THE DISPLAY JUST STARTS TO FLASH
“ RECEIVING AUDIO ” ADJUST BACK AND FORTH TO BE SURE IT IS JUST ON THE
EDGE OF STARTING TO FLASH “ RECEIVING AUDIO ”
3 _ TURN “ RX AUDIO IN ” CLOCKWISE 1 FULL TURN PAST THIS POINT
ADJUST THE LEVEL OF THE WAKE - UP TONES AND RADIO AUDIO TO
THE PA SYSTEM
GENERATE A 1000HZ TONE INTO THE RADIO AT 1.5 KHZ DEVIATION. THEN ADJUST RA-
DIO TO PA FOR A GOOD LEVEL OF THE 1000HZ TONE TO THE PA SYSTEM.
Go to Program - Setup. PRESS 1, 2 OR 3 TO GENERATE A WAKE - UP SEQUENCE. ADJUST
WAKE - UP TONES TO PA FOR A GOOD LEVEL.
PRESS 4 TO RESET THE RELAYS WHEN DONE.
TABLE OF CONTENTS