Sega WaveRunner GP, Owner'S Manual

Page: 59 / 76

50
www.seuservice.com
www.seuservice.com
51
17 - 2 ERROR MESSAGE
This work should be performed by the Location's Maintenance Man or Serviceman.
Performing work by non-technical personnel can cause accidents.
Should any errors other than listed by this manual or by NAOMI Service Manual
occur, contact where the product was purchased from or an office described in this
manual. Failing to comply with this instruction can cause accidents.
This product displays the error on the screen if the faulty is detected. If an error is displayed, be sure
to take action against it according to the appropriate cause and countermeasures listed below.
It may be displayed the error other than listed by this manual or by NAOMI Service Manual. In that
case, contact where the product was purchased from or an office described in this manual without
operating it selfishly.
DISPLAY NETWORK ERROR: NO MASTER SITE
CAUSE No MASTER setting in Communication Mode.
COUNTERMEASURES Perform the Communication Mode setting in the Game Assignments. Set
one of the machines to MASTER and all others to SLAVE.
DISPLAY NETWORK ERROR: DUPLICATE MASTER SITE
CAUSE MASTER setting is duplicated in Communication Mode.
COUNTERMEASURES Perform the Communication Mode setting in the Game Assignments. Set
one of the machines to MASTER and all others to SLAVE.
DISPLAY NETWORK ERROR: NO SLAVE SITE
CAUSE No SLAVE setting in Communication Mode.
COUNTERMEASURES Perform the Communication Mode setting in the Game Assignments. Set
one of the machines to MASTER and all others to SLAVE.
DISPLAY NETWORK ERROR: TOO MANY NODES SITE
CAUSE Too many machines are connected.
COUNTERMEASURES Up to 4 machines can be connected to allow to enjoy communication
play.
DISPLAY NETWORK ERROR: DUPLICATE CABINET ID
CAUSE The number of Cabinet ID is duplicated in Communication Mode.
COUNTERMEASURES Change the number of Cabinet ID for every seat in the Game Assign-
ments.
DISPLAY DRIVE BD ERROR: E2H
CAUSE Connection to Eliminator board is bad.
COUNTERMEASURES Check Connections from Eliminator board to Drive Board.
WARNING!