Sega TOP SKATER, Owner'S Manual

Page: 39 / 107

36
7 - 10 BOARD SETTING
In the Board setting, the value for each of CURVING AND SLIDE Volumes (which detects the operation of the
Skate Board) can be set.
STANDARD
Setting the value set at the time of centering automatically
determines the input range.
MANUAL
Manually sets both of the value set at the time of centering
and the input range (maximum and minimum).
DATA
Indicates the Skate Board’s present Volume value. When the
Skate Board is operated, the value varies.
CENTER
Present Volume value set at this time of centering the Skate
Board.
MINIMUM
The Volume’s Mimimum value set at present.
MAXIMUM
The Volume’s Maximum value set at present.
If the Skate Board can not be operated satisfactorily even
after the Volume setting is performed in this mode, adjust or
replace the Volume by refering to Section 8.
In the MENU MODE, selecting the BOARD SETTING
displays the screen shown left. This mode allows for setting
the centering position value and in-out range of the Volume
which detects the operation of the Skate Board. The Skate
Board Volume value differs depending on the specific
machine and also, can be deviated during transportation.
After installation and assembling, check the Volume value
and its variations in this mode. If the Value is widley varies
from the recommended value, set the Volume value in the
following procedure:
These are two setting methods, i.e., STANDARD and
MANUAL.
Enter the BOARD SETTING mode.
Select STANDARD and press the TEST BUTTON. The
screen changes to Fig. 7.10b.
Set the Skate Board in the center/flat position. The Value
obtained at this time is the CENTER value.
Press the TEST BUTTON to exit from BOARD SETTING,
display the BOARD SETTING DATA HAS BEEN DIS-
PLAYED message, and change the setting. The screen
returns to the menu mode.
GUN SETTING
STANDARD
MANUAL
>EXIT
CURVING SLIDE
DATA 80 80
CENTER 80 80
MINIMUM 4f 3e
MAXIMUM b1 c2
SELECT WITH SERVICE BUTTON
AND PRESS TEST BUTTON
Fig. 7.10a BOARD SETTING
Fig. 7.10b STANDARD SETTING
BOARD SETTING
BEFORE EXITING [ BOARD SETTING ] ,
SET THE BOARD IN THE CENTER/FLAT POSITION .
MESSAGE
CURVING SLIDE
DATA 80 80
CENTER 80 - 80 80 - 80
MINIMUM 4f - 4f 3e - 3e
MAXIMUM b1 - b1 c2 - c2
PRESS TEST BUTTON TO EXIT