Sega SONIC DASH EXTREME, Owner'S Manual

Page: 14 / 160

HANDLING PRECAUTIONS
1
1 1
1 HANDLING PRECAUTIONS
When installing or inspecting the machine, be very careful of the following points and pay attention to ensure that
the player can enjoy the game safely.
Non-compliance with the following points or inappropriate handling running counter to the cautionary matters
herein stated can cause personal injury or damage to the machine.
● Proceed with checks and tasks as indicated in these instructions. If instructions
are not followed, or if tasks and/or checks are neglected, an electric shock or
other very serious accident, even fatal accident can occur. Also, customers
could be injured while operation the product.
● Before performing work, be sure to turn the power off. Performing the work with-
out turning the power off can cause an electric shock or short circuit. In cases
where work should be performed in the status of power on, this manual always
states to that effect.
● To avoid an electric shock or short circuit, do not plug in or unplug quickly.
● To avoid an electric shock, do not plug in or unplug with a wet hand.
● Do not expose power cords or earth wires on the surface, ( fl oor, passage, etc.)
If exposed, the power cords and earth wires are susceptible to damage. Dam-
aged cords and wires can cause an electric shock or short circuit.
● To avoid causing a fi re or an electric shock, do not put things on or damage
the power cords.
● When or after installing the product, do not unnecessarily pull the power cord. If
damaged, the power cord can cause a fi re or an electric shock.
● In case the power cord is damaged, ask for a replacement through where the
product was purchased from or the of fi ce herein stated. Using the cord as is
damaged can cause fi re, an electric shock or leakage.
● Be sure to perform grounding appropriately. Inappropriate grounding can
cause an electric shock.
● Be sure to use fuses meeting the speci fi ed rating. Using fuses exceeding the
speci fi ed rating can cause a fi re or an electric shock.
● Be sure that connections such as IC BD are made properly. Insuf fi cient insertion
can cause an electric shock.
● Speci fi cation changes, removal of equipment, conversion and/or addition, not
designated by SEGA are not permitted.
- Failure to observe this may cause a fi re or an electric shock. Non-compliance
with this instruction can have a bad in fl uence upon physical conditions of the
players or the onlookers, or result in injury during play.
- SEGA shall not be held responsible for damage, compensation for damage to
a third party, caused by speci fi cation changes not designated by SEGA.
● Do not perform any work or change parts not listed in this manual. Doing so
may lead to an accident.