Sega Rally 2 DX, Owner'S Manual

Page: 57 / 129

53
13-3 TOSHIBA PROJECTOR
Do not touch places other than those specified. Touching places not
specified can cause an electric shock or short circuit accident.
TOSHIBA PROJECTOR has two different types, i.e., one equipped with the Control Panel
and the other without the Control Panel. When adjusting, be sure to confirm the type used.
TOSHIBA PROJECTOR CONTROL PANEL
STATIC CONVERGENCE ADJUSTMENT (With the Control Panel)
Do not press undesignated key. Pressing any undesignated key can
cause malfunction and adjustment fault. Should the key be pressed by
mistake, turn power off and turn it back on again.
During adjustment, should the screen image be abnormally disfigured
due to static electricity and other cuases, do not have adjustment
status stored, and be sure to turn power off.
Operate the Remote Control towards the PTV screen. If directed other
than to the PTV screen, the Remote Control does not function.
Unless the CONV ADJ SW is ON, remote control operation is not
acceptable. At the time of shipment, the SW is set to ON. If remote
control is not accepted, check status of this SW.
Direct the remote control towards the PTV screen and keep the Test
Key pressed down for approxiamtely 3 seconds. The adjustment
mode should appear on the screen and the screen turns into the green
test pattern.
On the screen, the cross pattern and the square frame line will be
projected. However, due to the TV mask, the up/down lines cannot be
seen.
1
2