Sega PRIMEVAL HUNT, Owner'S Manual

Page: 68 / 137

CONTROL
UNIT
61
10
• When working with the product, be sure to turn the power off. Working with the
power on may cause an electric shock or short circuit.
• Be careful not to damage the wires. Damaged wires may cause an electric shock, short
circuit or present a risk of fire.
• Exercise due caution in performing soldering work. If soldering iron is handled
carelessly, there could be fires or burns.
• When fastening plastic parts, be careful not to tighten screws or nuts excessively. If
these are tightened to excess, parts could be damaged, resulting in injuries from
fragments, etc.
• After the unit has been disassembled and reassembled again, check carefully to be
sure that there are no gaps or rattling at the junctions and that the trigger can be
operated smoothly. If there are gaps or rattling, or if operation is not satisfactory, the
players could get fingers or hands caught, resulting in injury.
• Be sure to inspect gun surfaces for cracks and damage. Players could be injured if they
play when the unit is cracked or damaged.
• Assemble so that there is no gap between the L and R covers. If there is a gap or
rattling, the players could get fingers or hands caught, resulting in injury.
• Once the product has been disassembled, use slack preventive agent (product No. :
090-0012-N). Coat screws with suitable amounts of this agent and then tighten them.
If this agent is not used, the product might start rattling or come apart.
• Use the slack preventive agent prescribed in these instructions. If any other agent is
used, there could be chemical changes that inhibit the use of screws and part surfaces
could be damaged.
• Be careful not to damage or lose small parts or screws.
• When a part has been replaced, be sure to always make adjustments and check
conditions in Test Mode.
CONTROLLER UNIT
10