Sega GHOST SQUAD - EVOLUTION, Manual

Page: 33 / 133

28
ASSEMBLY AND INSTALLATION
6
● Be careful not to damage the DVD wire by getting it caught between objects,
etc. Doing so may cause a short circuit or fire.
● The following explanation assumes that the product has been assembled prop-
erly as explained above. If there is an error or if the product operates in a man-
ner other than as indicated below, cut off the power supply immediately. Fail-
ure to do so may result in a fire or electrical shock.
● If you look directly at the laser beam in the DVD DRIVE, you could suffer vision
impairment. Do not look inside the DVD DRIVE.
1
Before supplying the power, you must make sure the DVD wire is not pinched or trapped.
2 Turn the main switch of the AC unit to ON and engage the power supply.
3
The LINDBERGH start-up screen appears. Wait for at least one minute. The error state is established.
Check to be sure it is “Error 22.” If it is “Error 22,” proceed to the next operation. If it is not “Error 22,”
refer to the LINDBERGH Service Manual and take corrective action.
Prepare the supplied DVD software kit and the separately sold DVD DRIVE and DVD wire. (See Chapter 5.)
6 ENGAGEMENT OF POWER SUPPLY (SOFTWARE INSTALLATION)
● The software is not installed on the game board (LINDBERGH) when the power
supply is engaged, so the “Error 22” message is not a malfunction. However,
if there is another error display, or if there is no video output at all, there might
have been an error in product assembly, wiring connections might be faulty, or
the LINDBERGH might not be functioning properly.
● After the power supply is engaged, wait for “Error 22” message to be displayed.
If the product is indiscriminately operated in any way beforehand, there could
be unexpected problems or malfunctions, as well as damage to parts.
● Once “Error 22” is displayed, set the DVD-ROM in the DVD DRIVE and re-engage
the power supply. Installation takes place.
● After the power supply is engaged, the DVD DRIVE tray will not come out for
about 30 seconds even if you press the switch. This is due to DVD DRIVE initial-
ization.
● The DVD DRIVE tray can come out or return only while the power supply is en-
gaged. The tray cannot be opened or closed while the power is off.
● Even after the software has been installed, store the DVD software kit, DVD DRIVE
and DVD wire in a secure location.
● If for any reason installation cannot be completed, an error is displayed. Refer
to the service manual and take corrective action.