Sega Clay Challenge, Owner'S Manual

Page: 11 / 66

PRECAUTIONS REGARDING INST
ALLA
TION LOCA
TION
2
3
PRECAUTIONS REGARDING INSTALLATION LOCATION
2
2-1 LIMITATIONS OF USAGE
This product is an indoor game machine. Do not install it outside. Even indoors,
avoid installing in places mentioned below so as not to cause a fire, electric shock,
injury and/or malfunction.
- Places subject to rain or water leakage, or places subject to high humidity in the
proximity of an indoor swimming pool and/or shower, etc.
- Places subject to direct sunlight, or places subject to high temperatures in the
proximity of heating units, etc.
- Places filled with inflammable gas or vicinity of highly inflammable/volatile
chemicals or hazardous matter.
- Dusty places.
- Sloped surfaces.
- Places subject to any type of violent impact.
- Vicinity of anti-disaster facilities such as fire exits and fire extinguishers.
- Areas where the temperature exceeds the applicable temperature (ambient
temperature) range of 5 to 30 degrees centigrade.
• Be sure to check the Electrical Specifications. Ensure that this product
is compatible with the location's power supply, voltage, and frequency
requirements. A plate describing Electrical Specifications is attached to the
product. Non-compliance with the Electrical Specifications can cause a fire and
electric shock.
• This product requires a breaker and earth mechanism as part of the location
facilities. Using the product without these can cause a fire and electric shock.
• Ensure that the indoor wiring for the power supply is rated at 15 A or higher
(AC single phase 100 V ~ 120 V area). Non-compliance with the Electrical
Specifications can cause a fire and electric shock.
• Be sure to use an independent power supply equipped with an earth leakage
breaker. Using a power supply without an earth leakage breaker can cause an
outbreak of fire if a power surge occurs.
• Putting many loads on one electrical outlet can cause generation of heat and a
fire resulting from overload.
• When using an extension cord, ensure that the cord is rated at 15 A or higher (AC
100 V ~ 120 V area). Using a cord rated lower than the specified rating can cause
a fire and electric shock.