Sega CAPTO CRANE, Operating Instructions Manual

Page: 4 / 25

INSPECTIONS IMMEDIATELY AFTER TRANSPORTING THE PRODUCT TO THE LOCATION
•
SPECIFICATION CHANGES (REMOVAL OF EQUIPMENT, CONVERSIONS AND ADDITIONS) NOT
DESIGNATED BY SEGA ARE NOTALLOWED
The parts of the product include warning labels for safety, covers for personal protection, etc. It is very hazardous
to operate the product by removing parts and/or modifying the circuits. Should doors, lids and protective parts be
damaged or lost, refrain from operating the product, and contact where the product was purchased from or the
office herein stated.
SEGA shall not be held responsible for any accidents or compensation for damage to a third party
resulting from the specifications not designated by SEGA
•
ENSURE THAT THE PRODUCT MEETS THE REQUIREMENTS OF APPROPRIATE ELECTRICAL
SPECIFICATIONS
Before installing the product, check for electrical specifications. SEGA products have a nameplate on which the
electrical specifications are described. Ensure that the product is compatible with the power supply voltage and
frequency requirements of the location. Using any electrical specifications different from the designated
specifications can cause a fire and an electric shock
•
INSTALL AND OPERATE THE PRODUCT IN PLACES WHERE APPROPRIATE LIGHTING IS
AVAILABLE, ALLOWING WARNING LABELS TO BE CLEARLY READ
To ensure safety for the customers, labels and printed instructions describing potentially hazardous situations are
applied to places where accidents can be caused. Ensure that where the product is operated has sufficient lighting
allowing the warnings to be read. If any label is peeled off, apply it again immediately. Please place an order with
where the product was purchased from or the office herein stated
•
WHEN HANDLING THE MONITOR, BE VERY CAREFUL (APPLIES ONLY TO PRODUCTS WITH
MONITORS)
Some of the monitor parts are subject to high tension voltage. Even after turning off the power, some portions
are still subject to high tension voltage. Monitor repair and replacement should be performed only by those
technical personnel who have knowledge of electricity and technical expertise
•
BE SURE TO ADJUST THE MONITOR PROPERLY (APPLIES ONLY TO PRODUCTS WITH MONITORS)
Do not operate the product leaving on-screen flickering or blurring as it is. Using the product with the monitor not
properly adjusted may cause dizziness or a headache to an operator, a player, or customer
•
WHEN TRANSPORTING OR RESELLING THIS PRODUCT, BE SURE TO ATTACH THIS MANUAL TO
THE PRODUCT
*
In the case where commercially available monitors and printers are used in this product, only the contents relating
to this product are explained herein. Some commercially available equipment has functions and reactions not
stated in this manual. Read this manual together with the specific instruction manual of such equipment
*
Descriptions herein contained may be subject to improvement changes without notice
* The contents described herein are fully prepared with due care. However, should any question arise or errors
be found, please contact SEGA
Normally, at the time of shipment, SEGA products are in a state allowing for usage immediately after transporting
to the location. Nevertheless, an irregular situation may occur during transportation. Before turning on the power,
check the following points to ensure that the product has been transported in a satisfactory status:
Are there any dented portions or defects (cuts, etc.) on the external surfaces of the cabinet? Are casters
and/or adjusters damaged?
Do the power supply voltage and frequency requirements meet with those of the location?
Are all wiring connectors correctly and securely connected? Unless connected in the correct way, connector
connections cannot be made accurately. Do not insert connectors forcibly.
Do power cables have cuts and/or dents? Are all
accessories available?
Can all doors and lids be opened with the accessory keys? Can doors and lids be firmly closed?