Seg KM 1025, Instruction Manual, Page: 49 / 56

49
7. Press the button ‘MAHLWERK AUS’ (18). The LED light next to the button lights up
and confirms that the grinder is turned off.
8. Press the On/Off control button (20) to start the device. The LED light next to the
button lights up to confirm the start of operation.
9. Run the heated water through the device until the water tank is empty and the LED
lamp next to the On/Off button (20) goes out.
10. Empty the coffee pot (6).
11. To thoroughly clean the device repeat the procedure 2–3 times.
12. Press the On/Off button (20) to switch off the hot plate (8).
13. Empty and clean the coffee pot (6).
Descaling
1. Make sure there are no coffee residues in the permanent filter (2) and that the coffee
pot (6) is clean.
2. Fill the coffee pot (6) with cold water up to the mark ‘12’.
3. Open the lid of the water tank (13) and pour the water into the water tank (12).
4. Add descaler (dosage according to instructions) or 80 ml vinegar essence to the
water in the water tank (12).
5. Close the lid of the water tank (13).
6. Place the coffee pot (6) on the hot plate (8).
7. Connect the device with the power supply.
8. Press the button ‘MAHLWERK AUS’ (18). The LED light next to the button lights up
and confirms that the grinder is turned off.
9. Press the On/Off control button (20) to start the device. The LED light next to the
button lights up to confirm the start of operation.
10. Run the heated water/descaler through the device until the water tank is empty and
the LED lamp next to the On/Off button (20) goes out.
11. Press the On/Off button (20) to turn off the hot plate (8).
12. Empty the coffee pot (6).
13. After completion of descaling rinse the device 2 times to remove remains of the
water/descaler mixture, see above chapter – RINSING THE DEVICE.