INSTALL AND OPERATION MANUAL EXT
|
15
MAINTENANCE
Maintenance Schedule servicing is essential to ensure the
cooler operates efficiently for many years. It must be carried out
by a qualified, licensed service technician.
It is important to note that all evaporative coolers have
components that may need periodic replacement (eg. filter
pads, hoses, o-rings etc).
Note!
It is important that only new Seeley International factory
authorised replacement parts be used in this cooler. Failure to
do so may result in voidance of the factory warranty, improper
cooler and unsafe operation.
For detailed servicing requirements refer to the Maintenance
Schedule section.
Note!
Failure to carry out the Maintenance Schedule services
will void your warranty cover.
While installation is not covered by warranty (e.g. duct work,
roof penetrations, electrical and water connections etc.), these
items should be checked as they can affect the performance
(and/or safety) of the cooler. For this reason they are included in
the Maintenance Schedule.
HEALTH REGULATIONS
In some regions, regulations require that evaporative air coolers
be serviced at specific intervals. Ensure all maintenance is done
in accordance with any local and national regulations
(e.g. AS/NZ 3666.2:2011).
ACCESS FOR SERVICING AND MAINTENANCE
WARNING! As your cooler is mounted on the roof, we
suggest that any maintenance or checks be carried out by
an authorised Seeley International dealer or service agent.
Climbing onto the roof can be hazardous and could result
in injury to you and damage to your property.
Working at heights requires additional safety precautions.
Required clearances around the cooler for maintenance and
servicing are shown below.
FLAT TANK
ALL COOLERS
1.0m (3.5')
1.0m (3.5')
0.6m (2')
1.0m (3.5')
ALL COOLERS
FRONT
REAR
SIDE
SIDE
ILL2645-C
ALL COOLERS
1.0m (3.5')
SLOPE TANK
ILL2645-C
Specific job sites may incur additional charges for servicing in
order to provide safe access to the cooler for servicing, which
may include, but not limited to sites:-
•
with a roof pitch >30°
•
with limited access to the roof
•
where roof material or the condition of does not allow safe
access
•
where the roof access point is > 13’ (4m) above ground
level
•
where the cooler is located too close to a fall edge
•
which are not structurally capable of supporting the weight
of the cooler and service technicians
Extra service or warranty charges may apply for the cost of
any equipment or additional labour involved in providing
safe access to the cooler.
