ILL1085-A
3
Starting your cooler
The ON/OFF button turns the air cooler on and
off.
There are two modes of operation to choose
from, Automatic mode or Manual mode. When
the air cooler is turned on, it will start in the
mode of operation it was in when last turned off.
If your air cooler has not been operated for a
while, then when you start it, “Pre Cool Cycle”
may sometimes flash on the display as shown.
This indicates that the water pump will operate to
saturate the cooling pads for a few minutes
before the fan is turned on. This is to ensure that
when the fan starts, only cool air enters the
building.
WALL CONTROL FUNCTIONS
WALL CONTROL FUNCTIONS -
cont.
SEELEY INTERNATIONAL –
OWNER’S MANUAL
®
CPL LCB BM Evaporative Cooler
®
4
Automatic mode
Manual mode
The AUTO button is used to select Automatic
mode or Manual mode. When “Auto” is displayed
the cooler is under Automatic control and will
operate according to the temperature sensed at
the wall control.
When the air cooler is turned on, it will read the
temperature and set the cooler operation
accordingly. If the temperature increases at the
wall control, then the fan speed will increase. As
the temperature decreases the fan speed will
decrease until the cooler turns off.
Press S or T to overide the automatic
cooling level setting and adjust your room
temperature.
To switch to Manual mode, press AUTO until
“Man” appears in the display. In Manual mode
the cooling level can be manually adjusted.
In Manual mode, press
to choose
between circulating cool air or un-cooled air.
When “Cool” is displayed, fresh cool air will
circulate into the building. When “Vent” is
displayed as shown, fresh un-cooled air will
circulate through the building.
Press S to increase the fan speed and
circulate more air. Press T to decrease the fan
speed and circulate less air. Press once to
change the speed by one increment. Hold the
button down to change the speed more quickly.
COOL
AUTOMATIC MODE DISPLAY
MANUAL MODE DISPLAY
