SeeEyes SC-IPR3001E, User Manual

Page: 7 / 16

Release Version 1.8
6
4. Daisy-Chain Connection
4-1. Overview
Up to 3 transmitters can be configured with 1 receiver for Daisy-chain connection.
4-2. How to Use Daisy-Chain Connection
<How to configure Daisy-Chain>
a) Perform Pairing by connecting 1 Tx(Transmitter) to Rx(Receiver).
b) Connect additional Tx to Paired Tx with t T-connector, etc.
c) In the OFF state of Paired Tx,
repeat ON/OFF 2 times within 2 seconds by pressing Paired Tx’s
Switch (Func. button).
d) Within 1 minute after operating ‘c’, in the OFF state of additional Tx, repeat ON/OFF 3 times
within 2 seconds by pressing additional Tx’s Switch (Func. button).
<How to check Daisy-Chain status>
1) When entered in Daisy-Chain mode, the PWR LED blinks and changes to normal state after
blinking up to 2 minutes.
2) Completed within 30 seconds ~ 1 minute after operating ‘d’.
3) If the Link LEDs of Paired Tx and additional Tx remain ON for over 10 seconds, Daisy-Chain
connection is done.