12
signal parameters that need analysis, e.g. Freq(frequency), Duty(dutyfactor), Vpp(peak-to-peak voltage)etc., the
measured value will be displayed at the lower right corner of the screen, as shown in the image below:
2.
2.
2.
2.
Example
Example
Example
Example Two
Two
Two
Two
：
Measure
Measure
Measure
Measure with
with
with
with C
C
C
Cursor
ursor
ursor
ursor
A cursor can be used to measure the time and voltage of the waveform very quickly.
（
1
）
Measure the cycle of signal source
Please operate according to the following steps:
�
Use “▲” or “▼” to choose Yn items in Measurement Area.
�
Press “M”
�
Use “◄” or “►” to choose CursorV1
�
Use “▲” or “▼” to adjust the position of CursorV1 to the crest.
�
Use “◄” or “►” to choose CursorV2
�
Use “▲” or “▼” to adjust the position of CursorV2 to the valley.
And get
：△
V=1.00mS i.e. the cycle of signal source. As shown in the image below:
Measured value
T1
T2
