SEDEMAC
TM
Format No: SED-OHA-QF-06, Rev 01
NOTE: This document is a property of SEDEMAC Mechatronics Pvt. Ltd. It shall not be communicated to or copied by anyone without the written permission of the company.
This document is controlled when it is printed.
Page 9 of 19
mm2 multi strand copper wire.
•
Connect positive terminal of an external source (AC/DC) to the pole terminal of the battery
charger. Connect NO terminal of battery charger to one terminal of the indicator device and
other to the ground terminal of the external source (AC/DC) to detect the absence of AC mains.
•
In order to operate the charger in manual boost mode, short the terminals of “Boost select” by
means of a wire.
The recommended torque while tightening screws at the connecting
terminals is 0.4 to 0.5 N-m.
4.3
Dimensions
4.3.1
Mounting Information
Below table gives the brief information about the battery charger mounting for both variants.
Table 1: Mounting Information parameters for CB1205 and CB1210
Parameter
Comments
CB1205
CB1210
Overall Size
165mm X 119mm X67mm
192mm X 129mm X67mm
Mounting type
Panel mounting
Panel mounting
Mounting hole centres
154.6mm X 40mm
181.6mm X 40mm
Mounting holes
Holes M4
Holes M4
Recommended Screw
M4
M4
Recommended Torque
0.8 Nm to 1 Nm
0.8 Nm to 1 Nm
Over tightening of the screws may damage the charger casing.
