v2.2 7/28/11
8
To Set and Run a Pattern:
a. Input SET preset 242 to begin pattern learning.
b. Send GOTO preset command so the camera will recognize this point as a pattern
point. For example, if the camera is to tour at point 1, 3, and 6 input GOTO preset
point 1, GOTO preset point 3 and GOTO preset point 1.
c. Input SET preset 243 to end pattern learning.
d. Input SET preset 247 to start pattern tour.
e. Input SET preset 248 to stop pattern tour.
8. TROUBLESHOOTING
a. No picture after applying power – (i) check all plugs and cables are securely
connected to the proper connectors; (ii) ensure your power supply is providing the
correct voltage and current.
b. The picture has ripples – (i) check to see if the power supply is experiencing AC ripple,
if so a filter may be required; (ii) determine if the monitor is faulty; (iii) determine if
other peripheral equipment is causing ripple and if so make the necessary
adjustments.
c. The picture background continuously changes color – a fluorescent lamp’s magnetic
field may cause color roll, therefore, reduce the number of fluorescent lamps or
increase the distance between the camera and the lamps.
d. The picture appears smeared – (i) the power supply voltage level may be unstable,
therefore, try another power supply; (ii) ensure the cables are correctly connected
and/or the cables are of the correct impedance.
e. Other interference may require a Securitytronix ground loop isolation filter.
f. Power is on, but the controller does not work – (i) check to make sure the DIP
switches for address and communications baud rate are properly set, (ii) check to
ensure the RS485 connections at the camera and the PTZ Controller have the same
polarity, (iii) check the integrity and continuity of the unshielded twisted pair (UTP)
control cable.
g. Additional troubleshooting assistance can be found on-line at
www.securitytronix.com
in addition to support from Securitytronix sales engineers at 1-610-429-1511.